Posted in Uncategorized

Make Your Own Soccer Pennant Banner

If you are looking for the DIY approach to make a custom football pennant, you are well on the right page. Ideally, the full process are going to be easier if you utilize a real pennant like a guide. This will make it far more for you to receive the measurements. So, let us get started and check out practical aspect on the project.

As said earlier, be sure you get an authentic product for assistance. For instance, may buy one yard of felt too. Next, it is possible to free-hand the telephone number cutting. Ideally, you may cut one number a tad smaller than the prior number for the layered look. Actually, the concept is to guarantee the numbers are of the best size for your pennant. If you’ll be able to get the shape right, you may get the project done in the initial stage. Next, stitching ought to be done.

Also, be sure to sew the most notable and sides of the tall rectangle to your pennant’s left side, which will create a rod pocket. This rod pocket will probably be used to the dowel.

The dowel rods aren’t expensive. You can get each bit for less than some money. So, the price won’t be problems if you are concered about your budget. It’s far better to get a few extra dowel rods in case you come up with a mistake during the process. You may use the spare dowel rods in this case.

You can make use of a tool being a branch trimmer to reduce them into two pieces. The one about the extreme right side is good for your private use. If you are which makes it for your daughter, always keep the length short. One benefit from shorter dowels is your daughter is able to keep better treating it.

You must ensure the dowel is secured inside pocket, that is necessary to stay away from the dowel from flying for the stands of visitors the primary time it’s waved. Make sure you mark the ending points with the rod pocket. You will use a sharpie marker or finger hold.

Your next step would be to get a sheet of duct tape (it has to be 6″ inches long). Once you have it, you must cut it by 50 %. This will present you with two small pieces. Beginning a lttle bit above the marked point, you must wrap the tape around. Next, it is best to add the opposite piece over it.

Here you need to note that the outer strips have a tendency to work being a stopper. Therefore, the strip that faces out won’t slide down or up. On another hand, the inner strip offers just the best amount of grip towards the rod pocket. This way you may not lose your pennant. Moreover, the grip really should not be so strong that taking off the dowel becomes impossible at the end from the season. After all, you should utilize the same pennant next year also.